SignGo Home
 
  Welcome, Guest. Please Login or Register
 
  HomeHelpSearchLoginRegister  
 
Page Index Toggle Pages: 1
cutter missing bits (Read 86 times)
06. May 2018 at 15:53

Joshie69   Offline
Junior Member

Posts: 10
**
 
my cutter (in which is a pixmax 721pe in which i know is a cheap one) misses bits of the cutting process. If it draws a circle it will get 99.9% of the way round and leave a tiny bit in which i have to manually cut with a knife. Iv tried text shapes and vectors but its the same on anything i cut wether its large or small. I can email pictures to show you what i mean

 
IP Logged
 
Reply #1 - 04. Jun 2018 at 17:37

Kevin Wallace   Offline
Global Moderator
SignGo Support

Posts: 785
*****
 
Hi

First check the tool offset matches the blade you are using. This is usually about 0.25 or 0.3mm. (Cut command > Cut tab > Setup > Tool offset)
 
IP Logged
 
Page Index Toggle Pages: 1