SignGo Support Forum
http://www.signgo.com/cgi-bin/yabb2/YaBB.pl
Your Support Questions >> Post your support questions here >> NEW PROBLEM GRAPHTECH PLOTTER
http://www.signgo.com/cgi-bin/yabb2/YaBB.pl?num=1614643030

Message started by stickershock23 on 01. Mar 2021 at 23:57

Title: NEW PROBLEM GRAPHTECH PLOTTER
Post by stickershock23 on 01. Mar 2021 at 23:57
OK i added a new cutter..    finally got that figured out..

BUT I ran into an issue   My 52" Graphtec   when I cut  from my rip cut software  everything is fine..

but when I cut from  SIGNGO   everything is about 1/3 rd the size it should be..

  HELP 

Title: Re: NEW PROBLEM GRAPHTECH PLOTTER
Post by Kevin Wallace on 16. Mar 2021 at 18:11
Cured by setting step size in SignGo to 0.025

SignGo Support Forum » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2021. All Rights Reserved.