SignGo Support Forum
http://www.signgo.com/cgi-bin/yabb2/YaBB.pl
Signgo Support Information >> Cutting Issues >> How do I drive my Creation Cutter?
http://www.signgo.com/cgi-bin/yabb2/YaBB.pl?num=1100025038

Message started by Kevin Wallace on 10. Nov 2004 at 01:30

Title: How do I drive my Creation Cutter?
Post by Kevin Wallace on 10. Nov 2004 at 01:30
Creation PCUT CT series cutters are supported.

CT Series fitted with USB Port
This model may actually be labelled as CR Series. You can identify the actual series type by looking at the display when you switch it on. It will display CT or CR accordingly. CT Series uses a virtual COM port driver. If you are having problems please ensure you download the newest driver from here.

CT Series fitted with Serial/Parallel ports
Please click here  for full details.

CR Series USB
The CR series (pure USB) is supported by SignGo from Version 1.17. You can identify the CR Series by looking at the display when you switch it on. It will display CR if it is fitted with a "pure USB" port. If it is fitted with a virtual COM port it will display CT, in which case refer to above. Note: The CR series does not support contour cutting.

SignGo Support Forum » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2021. All Rights Reserved.